This is a two component solvent free amine cured 100% solids epoxy intumescent coating. Specially designed asan intumescent coating to provide fire protection for steel in hydrocarbon pool fires for different types ofstructures and equipment. No additional reinforcing mesh is required. To be used as mid coat as part of acomplete system in atmospheric environments. Suitable on approved primers on carbon steel, aluminum, hotdipped galvanized steel and stainless steel substrates, subject to certification.
Where To Use
Typically used in the oil, gas and energy industries. Suitable in both offshore and onshore environments for thepassive fire protection of structural carbon steel, stainless steel, GRP and concrete, subject to certification.In line with all epoxy intumescent technologies, the product is suitable for use on pipe work, vessels orequipment. At higher service temperatures, Jotatherm TB550 should be used as thermal syntactic insulationbetween substrate and Jotachar or as thermal insulation on top of Jotachar for atmospheric heat radiation.
Advantages
- Increased productivity, no mesh installation
- Saves up to 50% in time and costs
- Less risk
- Faster project completion
- Less downtime, no mesh inspection points
- Continuous application
- Lower life cycle cost
Recommended thinner/cleaning solvent
| Thinner: | Jotun Thinner No. 7/Jotun Thinner No. 17 / Jotun Thinner No. 10 |
| Thinning max: | 5 % |
Thinning is typically 2-3 % by volume for modified airless spray and manual application.
For rolling, use Jotun Thinner No. 7 or Jotun Thinner No. 17.
Note: Korean VOC regulation “Korea Clean Air Conservation Act” and its corresponding thinning limit will prevailover recommended thinning volumes.
| Cleaning solvent: | Jotun Thinner No. 17 |
Colors:
Fully tint-able
